Axis Customer Forum

It is currently Sun Jun 16, 2019 3:14 am

All times are UTC




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Dec 04, 2018 8:24 pm 

Joined: Tue Oct 29, 2013 5:58 pm
Posts: 12
I'm bench testing a P3235 with a T8331, as part of a replacement project. ( I am replacing some 3346' to get PIR input from the T8331 )

The P3235 is powered from a Cisco POE switch, and the only other device on the switch is the laptop I am using to configure the pair.
The T8331 is connected by 22/4 alarm wire, with only 3 connectors: +, -, and signal.
The T8331 is receiving 12V or so from the camera.

When the T8331 is in test mode the red LED shines for motion, and I can hear the relay click.

but nothing happens in the IO 'State' display, nor in the Logs. An action I wrote to overly text when Input 1 is triggered never runs.

the state of the NC and the NO terminals in the PIR do not change due to activity when examined with a multimeter. The PIRs light will illuminate but no change on the terminals.

am I missing something here in my debugging?


Top
 Profile  
 
PostPosted: Tue Dec 11, 2018 3:50 am 

Joined: Fri Nov 14, 2014 1:38 am
Posts: 739
Q1. An action I wrote to overly text when Input 1 is triggered never runs.
A1. Use event to turn on the camera recording to sdcard instead as it is easier to configure for troubleshooting.

Without the P3235 unit' server report it is hard to troubleshoot.

If you are interested in further discussion, please contact me via Skype @ Cheng.Xin.SG


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
cron
Powered by phpBB® Forum Software © phpBB Group